HOT SET TESTER AND ELECTRICAL TESTERS


Elastocon design and manufactures instruments for hot set testing of cable material according to IEC 811-2-1, and also according to IEC 60811-507 and other technically equivalent standards.

Elastocon also manufactures testing equipment for measurement of the electrical conductivity or resistance in rubber or plastic material for cables.

Rubber polymers are naturally electrical insulators and rubber is also used in many applications as insulation materials for electrical cables. When carbon black is compounded in the rubber, it increases the electrical conductivity and the rubber becomes a semi-conductor. With adding of special types of carbon black, the rubber can change to be more conductive.

Several different methods had been developed to determine the electrical conductivity or resistance. In principle, a voltage is applied across a rubber sample and the electrical current, which passes through the rubber, is measured. This may appear uncomplicated, but in actual fact, it is challenging to achieve in practice due to normally very small currents need to be detected. Furthermore, the resistance of rubber changes with temperature, time of electric exposure and physical stress.

The Yasuda Seiki No. 199 Volt Endurance and Destruction Tester is a high-voltage tester that is used to measure the electrical breakdown strength of materials. It is widely used in the electronics industry to test the quality of insulation materials, such as enameled wire, printed circuit boards, and transformers.

The Yasuda No. 173-S Cut-Through Tester precisely determines the temperature at which enameled wire softens using the cross-over method

Available in: Singapore, Malaysia, Thailand & Indonesia



Hot Set Tester and Electrical Testers Products


Hot Set Tester EB 16-II

The ELASTOCON EB 16-II Hot Set Tester is used for performing hot set testing of cable material according to IEC 60811-2-1 and other equivalent standards.

Read More >>>


Hot Set Oven Basic EB 30

The ELASTOCON EB 30 Hot Set Oven Basic is used for hot set testing of cable material according to IEC 60811-507 and technically equivalent standards.

Read More >>>


Volt Endurance and Destruction Tester

Ensure electrical safety with the Yasuda Seiki No. 199 Volt Endurance and Destruction Tester. This powerful tool evaluates the dielectric strength of solid insulating materials, guaranteeing their ability to withstand voltage without breakdown.

Read More >>>


Cut-Through Tester (For Enameled Wire)

Ensure enameled wire perfection with the Yasuda Seiki No. 173-S Cut-Through Tester. This advanced tester pinpoints the exact temperature at which your wire's insulation softens,  preventing short circuits and guaranteeing optimal performance.

Read More >>>


Volume Resistivity Tester EE 01-III

The ELASTOCON Volume Resistivity Tester EE 01‑III is used for measurement of volume resistivity on conductive and semi-conductive rubber and plastic materials, according to ISO 1853 and ISO 3915.

Read More >>>


Resistance Tester EE 02

The ELASTOCON Resistance Tester, EE 02 is used for determination of electrical resistance on conductive and antistatic rubber products according to ISO 2878 and other equivalent standards.

Read More >>>


Volume Resistivity Tester EE 03-III

The ELASTOCON EE 03‑III Volume Resistivity Tester is an instrument used for determination of volume resistivity on semi-conductive materials, according to cable standard IEC 60502-2 and ASTM D257 fig 6 for insulating materials.

Read More >>>


Volume Resistivity Tester EE 04-II

The Elastocon EE 04‑II Volume Resistivity Tester is an instrument used for determination of volume resistivity on insulated materials according to ISO 14309, IEC 62631-3-1 and ASTM D257 fig 4.

Read More >>>

TOP